Heat & Glo • SUPREME-I30-NZ • 2417-900 Rev. E • 3/18
28
A. Wiring Requirements
NOTICE:
This appliance must be electrically wired
and grounded in accordance with local codes or, in the
absence of local codes, with
National Electric Code
ANSI/NFPA 70-latest edition
or the
Canadian Electric
Code CSA C22.1.
• This appliance is approved for use with 220/240VAC
Power Cord assembly (SRV2222-374) which has a
female plug in to accommodate all control options
and accessories. The power cord assembly must be
purchased separately and attached prior to installation.
See Figure 10.2. An outlet box may be installed in a
bottom back corner of the
existing solid fuel masonry or
factory built fireplace
to plug in the cord assembly, or the
supplied power cord may be routed out onto the hearth
to a nearby outlet.
• A 220/240VAC circuit for this product must be protected
with ground-fault circuit-interrupter protection, in compliance
with the applicable electrical codes, when it is installed in
locations such as in bathrooms or near sinks.
• Low voltage and 220/240VAC voltage cannot be shared
within the same wall box.
WARNING!
Risk of Shock or Explosion!
DO NOT
wire
220/240VAC to the valve or to the appliance wall switch.
Incorrect wiring will damage controls.
10
Electrical Information
B. IntelliFire™ Plus Ignition System Wiring
• Wire an outlet box (220/240VAC) in the bottom back
corner of the existing solid fuel masonry or factory
built fireplace
to plug in the power cord assembly (sold
separately). The purchased power cord assembly may
also be routed out onto the hearth to a nearby outlet.
• Refer to Figure 10.1, IPI Wiring Diagram.
• This appliance is equipped with an IntelliFire™ Plus
control valve which operates on a 6 volt/1.5 AMP system.
• Plug the 6 volt transformer plug into the appliance power
cord to supply power to the unit OR install 4 AA batteries
(not included) into the battery pack before use.
ON/OFF Switch
• An ON/OFF switch is included with the appliance
surround and should be attached to surround/facing.
(See Installation instructions for remote control/fronts).
• If desired an additional wall switch or thermostat may be
added to system.
