HDG Pelletmaster 15, Operation Manual, Page: 137 / 172

6 Using the heating system – Structure of the menus
137
10-02 Heating circuit 1
Supply temperature
( 60) 60°
• Supply temperature
Supply temperature for constantly controlled heating
circuits.
(0 - 100 °C)
10-03 Heating circuit 1
Preset room temp.
Day
( 22.0) 22.0°
• Preset room temperature for daytime
Set the desired temperature for daytime operation.
(15.0 - 30.0 °C)
10-04 Heating circuit 1
Preset room temp.
Night
( 14.0) 14.0°
• Preset room temperature for night-time
Set the desired temperature for night-time operation.
(10.0 - 25.0 °C)
10-05 Programme 1 CCT1
Mo Tu We Th Fr Sa Su
On 05:00 On 00:00
Off 22:00 Off 00:00
• Heating times
Up to two different heating times per day can be
programmed.
10-06 Programme 2 CCT1
Mo Tu We Th Fr Sa Su
On 00:00 On 00:00
Off 00:00 Off 00:00
• Heating times
Up to two different heating times per day can be
programmed.
10-07 Heating circuit 1
Outdoor temperature
Switch-off
( 20) 20°
• The temperature outdoors
If the preset outdoor temperature is not met, the heating
circuit pump is turned off.
(0 - 50 °C)
10-08 Heating circuit 1
Room influence factor
( 1.0) 1.0
• Room influence factor
The room influence factor expresses how strongly any
deviation of the room temperature should affect the
temperature of supply water leaving the boiler.
(0.1 - 5.0)
10-09 Heating circuit 1
Steepness
Char. heating curve
( 1.6) 0.8
• Char. heating curve
The steepness of the characteristic heating curve is used
to assign a certain supply temperature to a heating
circuit, depending on the temperature outdoors.
(0.5 - 3.5)
10-10 Indoor thermostat unit
CCT1
No
Yes
• Room sensor
Activate the room sensor.
10-11 Heating circuit 1
Parallel shift
( 0) 0°
• Parallel shift of the characteristic heating curve
Set the parallel shift of the characteristic heating curve.
(0 - 20 °C)
No. Display Description
Table 6/12 - Service level / 10 Heating CCT1