Hawk Senator S24S, Handbook

Page: 79 / 176

OPERATION
6
79
Senator S24S
01/2019 - Senator S24S Radar Manual v1.00 en
B
–
Test menu
Menu
No. Function Function description Selection list Default
B1 Simulation
B1.1 Set Value B1.1 Set Value B1.1 Set Value B1.1 Set Value
B1.1.2 Level This sets the device to a given test level
value. Make sure that menu item
C4.1.1 Current Out. 1 Var. is set to
"Level" before the device simulates a
level value. This procedure sends an
output signal that agrees with the test
reading. Output will change to the
selected value, independent of the
measurement data.
When you push [
^ ^ ^ ^
] to confirm the
value, the display shows the question
"Start Simulation?" Push [ ] or [ ] to
set the display to "Yes". Push [
^
^ ^
^
] again
to start the test. The device goes to
back to Normal mode after 1 hour.
Minimum access level to do the Minimum access level to do the Minimum access level to do the Minimum access level to do the
procedure:
procedure: procedure:
procedure: Expert
min-max:
-4900.0...+5100.0 m /
-192.91
+03
...+200.79
+03
in /
-16076...+16732 ft
1
B1.1.3 Distance This sets the device to a given test
distance value. Make sure that menu
item C4.1.1 Current Out. 1 Var. is set to
"Distance" before the device simulates
a distance value. This procedure sends
an output signal that agrees with the
test reading. Output will change to the
selected value, independent of the
measurement data.
When you push [
^
^ ^
^
] to confirm the
value, the display shows the question
"Start Simulation?" Push [ ] or [ ] to
set the display to "Yes". Push [
^ ^ ^ ^
] again
to start the test. The device goes to
back to Normal mode after 1 hour.
Minimum access level to do the
Minimum access level to do the Minimum access level to do the
Minimum access level to do the
procedure: procedure: procedure: procedure: Expert
min-max:
-4900.0...+5100.0 m /
-192.91
+03
...+200.79
+03
in /
-16076...+16732 ft
1
B1.1.4 Reflection This sets the device to a given test
reflection value. Make sure that menu
item C4.1.1 Current Out. 1 Var. is set to
"Reflection" before the device
simulates a level value. This procedure
sends an output signal that agrees with
the test reading. Output will change to
the selected value, independent of the
measurement data.
When you push [
^ ^ ^ ^
] to confirm the
value, the display shows the question
"Start Simulation?" Push [ ] or [ ] to
set the display to "Yes". Push [
^
^ ^
^
] again
to start the test. The device goes to
back to Normal mode after 1 hour.
Minimum access level to do the Minimum access level to do the Minimum access level to do the Minimum access level to do the
procedure:
procedure: procedure:
procedure: Expert
min-max:
0...100%
1
www.hawkmeasurement.com