Hawk Senator S24S, Handbook

Page: 64 / 176

6
OPERATION
64
Senator S24S
01/2019 - Senator S24S Radar Manual v1.00 en
6.3 Program mode
6.3.1 General notes
Change the settings of your device in Program Mode
Program Mode Program Mode
Program Mode. Data about the menus is given on page 77.
You can:
• Use the A Quick Setup
A Quick Setup A Quick Setup
A Quick Setup menu to change the display language, change the tag name, log in to
change settings, do standard setup and empty spectrum recording procedures.
• Use the B Test B Test B Test B Test menu to run diagnostic tests, read measurement and spectrum data.
• Use the C Full Setup C Full Setup C Full Setup C Full Setup menu to change settings. You can set up a conversion table for volume
or mass measurement, change current output values, change HART
®
settings, change how
the measurement data is shown in Normal mode, read device identification data, change
critical parameters for difficult process conditions, change the password, change
measurement units or reset the device to factory default settings.
CAUTION!
If you did not supply all installation data to the supplier before the delivery, the standard setup
procedure in the Quick Setup menu is mandatory.
It is not possible to enter the D Service D Service D Service D Service menu. This menu is for factory calibration and approved
personnel only.
www.hawkmeasurement.com