Haulotte Group xlb-4725a, Operator'S Maintenance Manual, Page: 8 / 118

HAULOTTE GROUP 1 SAFETY
8
BEFORE OPERATION
Ensure the following general safety precautions are followed before operating the aerial work
platform:
ALWAYS inspect the usage area for potential hazards, such as unstable or unlevel surfaces,
overhead obstructions and electrically charged wires or conductors. ALWAYS watch for moving
vehicles in the operating area.
ALWAYS conduct a thorough visual inspection of the aerial work platform before operation. Check
for damaged or worn parts, hydraulic leaks, damaged wiring, loose wiring conductors, damaged
outriggers, low tire pressure, uneven tire wear or tire damage. Check for any improperly operating
components.
NEVER operate the aerial work platform if any damage is observed or suspected.
Repair damaged or malfunctioning equipment before operation.
ALWAYS wear proper clothing. Wear protective equipment as required by Federal, State and Local
codes and regulations. Keep loose clothing, jewelry, gloves and hair away from moving parts.
ALWAYS wear a Safety Harness and energy-absorbing Lanyard, such as the Safety Harness and
Lanyard available through the Haulotte Group.
ALWAYS inspect platform floor and outrigger footpads for mud, grease, debris or other foreign
material. ALWAYS remove any such material from the aerial work platform before operation.
ALWAYS RED tag any part of this machine known or suspected to be damaged or malfunctioning.
ALWAYS remove a malfunctioning, damaged or defective aerial work platform from service. NEVER
operate an aerial work platform that has any known or suspected defect.
ALWAYS comply with the instructions found in Safety and / or Service Bulletins distributed by the
manufacturer / factory. Bulletins may contain critical procedures that supersede the information
contained in this manual.
NEVER operate this aerial work platform while under the influence of drugs or alcohol, while taking
prescription medications that may leave the operator drowsy or prone to dizziness, or while feeling ill.
NEVER modify, alter or change the aerial work platform in any way that would affect its original
design or operation.
NEVER deface, modify or obscure any decals or markings on the aerial work platform.
NEVER operate this aerial work platform in any way for which it is not intended.
NEVER operate this aerial work platform in explosive or flammable environments.
Before attempting aerial work platform operations, operator(s) should:
 Attend a training program as required by all Federal, State, and Local codes and regulations.
 Obtain, read and obey all safety precautions as indicated by manufacturer’s recommendations
and all Federal, State and Local codes and regulations.
 Become familiar with the location and use of all controls.
 Verify that there are no overhead obstructions or live power sources in the work area that could
interfere with the safe operation of the aerial work platform.

Cordon off the area surrounding the aerial work platform to keep personnel, vehicles and moving
equipment away from the aerial work platform while in use.

Position the aerial work platform on a firm and level surface.

Conduct a pre-operation inspection by performing all recommended daily service checks.
Refer to the “Equipment Maintenance” section of this manual.