HAULOTTE GROUP
5 CYLINDER REPLACEMENT
74
OUTRIGGER CYLINDER REPLACEMENT (CONTINUED)
At the base of the cylinder, unbolt and remove the pin retainer from each side of the pivot pin.
Remove the pivot pin using a hammer and a brass or hardwood drift.
Lift and remove the cylinder using an overhead hoist and lifting straps or equivalent.
Replace or reinstall the cylinder by following the above instructions in the reverse order of
removal.
Actuate the hydraulic system and check for leakage. Tighten hydraulic fittings as necessary.
Bleed trapped air from the hydraulic system by extending and retracting the outrigger with the
reservoir fill port cap on but not tightened. Allow several cycles of operation for trapped air to
escape. Repeat as necessary.
Summary of Contents for 3522A
