Bedienungsanleitung H1280
HASCO hot runner 17
Then, on the right side, select one of the operating modes.
Accept the selection with
.
The following operating modes are defined:
Operating mode
Function
Normal operating mode
In normal operating mode, the hot runner controller will control the output in
such a way that the measured temperature attains a specified setpoint
value. The output level (0...100%) at the output is calculated automatically.
In steady state operation, the actual value and setpoint value will be
identical.
Manual operation
During manual operation, a constant output level will be maintained at the
heating output. 0% means that the heating output is permanently off, 100%
means that the heating output is permanently on. Manual operation can be
used, for example, to manually maintain operation of the control zone until
a defective sensor is replaced.
OFF
Zone inactive = switched off. If the sensor is connected, the temperature
monitoring of the cut-off temperature remains active.
Monitoring operation
cs
With this setting, a zone can only be used for display and temperature
monitoring. No output power is emitted.
5.3.1.1.3 Setpoint values
1.
2.
3.
Setup > Quick start > Setpoint values
It is possible to enter setpoint values as the specified temperatures for different situations:
for normal operating mode, the standby value and the specified value for boosting.
Procedure:
First select the zones on the left whose setpoint value is to be displayed or changed.
On the right side, select one of the setpoint values described below
Open the box for entering the setpoint value with
Enter the desired value in the input box
Confirm with OK.
Value
Setting limits
Factory setting:
All zones will be switched off (OFF).
