Hardi HC 5500 SPRAY BOX III, Instruction Book

Page: 66 / 84

9 - Menu 5, Logbook
66
Menu 5.2 Data dump
How to dump data
Enables data dump to an office printer via a computer. This could be done, for example, by using the Hyper Terminal
function in Microsoft Windows.
Note that the Hyper Terminal has to be activated, and a communication cable (HARDI item no. 72271600) and a 12 volt
power supply to the Controller and Spray Box III is needed.
The Hyper Terminal baud rate should be set at one of the following before transmitting data:
•
19200 baud
•
9600 baud (default for HC 5500)
•
4800 baud
•
2400 baud
•
1200 baud
If only the display unit is to be removed from the tractor, a 12 volt power supply cable (HARDI item no. 72244500) is needed.
The following can be printed to an office printer:
Menu 5.2.1 Raw data
Enter this menu to dump the data at once without a column header.
Press to print out the data.
Menu 5.2.2 With header
Enter this menu to dump the data at once. This print method permits
the data to be set up with a column header.
Press to print out the data.
Menu 5.2.3 Configuration
Enter this menu to send the data to a computer at once. The data can
then be set up handled in a suitable computer program.
Connect a computer with a cable into one of the blue 9-pin sockets on
the back side of the controller.
÷
NOTE! While the controller is dumping data, the bottom line in the display reads “Dumping”.
DATA DUMP
Raw data
5.1.2
DATA DUMP
With header
5.2.2
DATA DUMP
Configuration
5.2.3