HappyJapan HCD3, Instruction Book

Page: 76 / 251

-DA -59
9-1
SEWING
9_1 O901
What to do if the thread breaks while sewing
If the thread breaks or runs out while sewing, the machine senses the break, stops, and moves
back several stitches from the break point.
(This prevents open sections in the design when sewing is resumed. See the thread break
section. 5-1)
If the upper thread breaks
Thread the upper thread again.
(Refer to 4-6)
In case bobbin thread breaks
Thread lower thread again.
(See bobbin winding 4-5)
CAUTION: To prevent accidents.
When performing a thread trim, be careful of
the needle which will pierce the fabric.
Example: An unsatisfactory gap between lines
because the machine stopped at a half point in
embroidery and the material shrunk.
Stopping and resuming sewing
Even if you need to turn off the machine in the
middle of embroidering, you will be able to
resume sewing from the stop point after turning
on the machine back on.
If you leave the machine off for too long, the
fabric may distort which will create gaps in
the embroidery design.
To suspend sewing
1. Stop the sewing by pressing the
button.
2. Press button.
The needle will go down and trim the thread.
3. Turn off the power switch.
To resume sewing from the last sewn position:
4. Turn on the power switch.
5. Press button.
After the carriage and frame move slightly, the
embroidery frame will return to the previous
position automatically.
6. Press and back up several stitches
from the stop point by pressing the 3-4
times.
7. Press .
8. Start sewing again by pressing the .
ON
OFF
ON
OFF
>>Stop Switch
CAUTION: To prevent accidents.
The frame moves quickly.
Keep your hands and body clear of the ma-
chine.