HappyJapan HCD3, Instruction Book

Page: 238 / 251

-RA -90
24-4
ERRORS AND WHAT TO DO
24_4 O512
y
190 Cut blade Thread cut knife is not at stop position. Follow the instructions below. 24-5
191 Cut Sensor Thread cut knife is not at stop position.
Check if threads are jammed around
the thread cutting knife.
Press the thread cutting button 2~3 times.
If error remains, contact your Dealer.
23-2
23-4
193 Catcher Thread catch hook is off its position.
Limit switch to detect position is not
"OFF".
Please follow the example below:
1. Check whether thread was actually cut
by thread cutting knife. If not, cut thread
and return catch hook to its normal
position.
2. If thread is actually cut, check if thread
catch hook on head has returned to its
position completely.
24-6
203 Install data Error has occurred during update of
program.
Check an update program.
215 Frm. drive err Frame movement did not complete
during normal movement. (Time over)
If this condition occurs frequently, contact
your Dealer.
217 Frm.drive data Frame movement data loose.
255 Default Error During embroidery, frame movement did
not complete until main shaft reach
"Lowest needle position".
Re-initialize machine speed setting.
Check adjustment of upper shaft timing.
(C point / L point)
If this condition occurs frequently, contact
your Dealer
25-2
. o N
y a l p s i D r o rr E s n o it u l o S e g a P