Hanwha Vision XRN-3210B4, User Manual

Page: 10 / 131

10_
getting started
Starting the SyStem
1.
Connect the power cable of the recorder to the wall outlet.
2. You will see the initialization screen.
The initialization process will last about 2 minute. If a new HDD is installed, the initialization process may take longer.
3.
The live screen appears with a beep.
The following symptoms might be observed when starting the system.
￭
If the HDD number is displayed at the bottom of the screen along with < > while the product is booting up, it indicates that the HDD is in recovery,
and for this reason booting up may take longer.
HDD 1, 2
￭
If the progress stalls while in < > state, it indicates that the HDD has problems. Visit your nearest customer service center to check the HDD.
HDD 2
getting started
inStallation Wizard
As shown below, proceed through each step of the < installation wizard >.
Install Wizard can only be accessed at factory reset. If you do not want to proceed, click < exit >.
￭
It will automatically change to the optimal monitor resolution and run the install wizard.
￭
If the install wizard does not run, remove the monitor connection from the back of the recorder, reboot the recorder and reconnect the monitor.
1.
In the <
language
> screen, select the language and press the <
next
> button.
2.
Set the video recording method on the <
Storage
> screen, and then click <
next
>.
●
Distributed mode : This function is only available for products that support distributed recording.
<
distributed mode > can be selected when there are two or more hard disks. This mode distributes the data and
saves it after the hard disk is formatted.
●
RAID mode : This function is only available for products that support RAID.
<
raid mode
> saves data by configuring the hard disk in the RAID format.
●
Single group mode : Saves data on one hard disk. If the hard disk is recognized as an unusable hard disk in the
recorder, the data can be saved after formatting the hard disk.