HQ Pro-Stitcher User Manual
07/23/12
3.6 Installation Instructions
Figure 3.7
Y-Rack Installation
1. Carefully lay the quilting machine on its power
pod side
(the left side, looking from the front)
.
Underneath the base plates, near the wheels on
the C-Pod side of the machine
(the side with the
thread tensioner and guides)
there will be either
two screws or two holes. If the screws are there,
use a large slotted
(flat)
screwdriver to remove the
screws
(see
Figure 5
)
.
2. Attach the Y-Rack as shown in
Figure 6
. The blue
rack should be toward the middle of the machine
while the bolt holes should be toward the outside.
Use the screws that were removed from the front
and rear base plates
(or use the two smallest screws
in the Base Plate Repair Kit (Page 3, D) if your
machine had no screws here)
to mount the Y-Rack
to the bottom of the front and rear base plates. Be
careful not to over-tighten the screws as the base
plate holes will strip easily. In case of accidentally
cross-threading or stripping one of the base
plate holes, an emergency repair kit
(D)
has been
provided.
3. If the screws in the base plates do not have slotted
heads and a nut driver cannot be fitted over the
screw head, please use one of the provided slotted
screws as a replacement
(D)
and use a slotted
screwdriver to tighten the screws in place.
Figure 3.8
Y-Rack
Y-Encoder