24
POST-ASSEMBLY
GRILL LIGHTING INSTRUCTION
VERY IMPORTANT:
ALWAYS INSPECT THE HOSE PRIOR TO EACH USE.
BEFORE LIGHTING:
• Inspect the gas supply hose before turning the gas ON. If there is evidence of cuts, wear,
or abrasion, it must be replaced before use. The replacement hose assembly must be that
specified by the manufacturer.
TO LIGHT MAIN BURNERS OF THE GRILL:
Read instructions before lighting.
1.
Open the lid and make sure all knobs are in the “OFF” position.
2.
Push and turn the knob slowly counterclockwise to the ignite
position ( ) as shown in
Fig. 11
. Keep pushing until the burner
lights and then release. Repeat for additional burners.
3.
If burner does not light, immediately turn the control knob to
the “OFF” position and repeat Step 2.
4.
If burner does not light after Step 3, TURN OFF GAS SUPPLY and WAIT 15 MINUTES for the
gas to disperse; then repeat Steps 1 and 2 or light with external flame.
Shutdown instructions:
1.
Turn all control knobs to the “OFF” position.
2.
Turn gas supply off at NG source.
IMPORTANT:
Lid must be open when lighting burners. TURN OFF GAS supply when not in use.
For Consumer Affairs, call: 1-800-267-2826.
Fig. 11
Summary of Contents for OG01
Page 7: ...7 BEFORE YOU BEGIN GRILL PARTS DIAGRAM GRILL PARTS DIAGRAM ...
Page 16: ...ASSEMBLY ASSEMBLY STEPS STEP 5 Side Shelves Fig 5b 16 Fig 5c ...
Page 39: ...39 AVANT DE COMMENCER SCHÉMA DES PIÈCES DU BARBECUE ...
Page 48: ...ASSEMBLAGE ÉTAPES DE L ASSEMBLAGE ÉTAPE 5 Tablettes latérales Fig 5b Fig 5c 48 ...
