Hamilton Beach OG01, Assembly Instructions Manual

Page: 22 / 64

POST-ASSEMBLY
LEAK TESTING
GENERAL
• Although all gas connections on the grill are leak-tested at the factory prior to shipment,
a complete gas tightness check must be performed at the installation site due to possible
mishandling in shipment or excessive pressure unknowingly being applied to the unit.
Periodically check the whole system for leaks or immediately check if the smell of gas
is detected.
BEFORE TESTING
1. Make sure that all packing material is removed from the grill, including the burner tie-down
straps.
2. Do not smoke while leak-testing.
3. Never leak-test with an open flame.
4. Make a soapy solution with one part liquid detergent (or soap) and one part water. Prepare a
spray bottle, brush, or rag to apply the solution to the connections.
5. Grill must be leak-tested outdoors in a well-ventilated area, away from ignition sources such
as gas-fired or electrical appliances and flammable materials.
6. Keep grill away from open flames and/or sparks while testing.
TO TEST
1. Make sure all control knobs are in the OFF position.
2. Turn on the natural gas supply. If you hear a hissing or rushing sound, turn gas off immediately.
There is a major leak at the connection. Correct before proceeding.
3. Check every connection from the natural gas supply to the manifold by brushing or spraying
the soapy solution on to the following:
A. Quick-disconnect coupler.
B. The full length of gas supply hose.
C. Gas supply connection to gas manifold.
4. If soap bubbles appear, there is a leak. Turn off supply valve IMMEDIATELY and retighten
connections, open supply valve again, and recheck for leaks.
5. If leaks persist or can’t be stopped, DO NOT ATTEMPT TO REPAIR. Call Consumer Affairs
for help.
6. Always close the supply valve after leak testing.
22