Hamilton Beach OG01, Assembly Instructions Manual

Page: 19 / 64

19
POST-ASSEMBLY
GAS CONNECTION
This is a natural gas-configured grill. Do not attempt to use LP gas unless the grill has been
reconfigured for LP gas use.
The installation of this appliance must conform with local codes or, in the absence of local
codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or CAN/CSA B149.1,
Natural Gas and Propane Installation Code, or CAN/CSA B149.2, Propane Storage and
Handling Code.
Your natural gas grill is factory-built to operate using natural gas only. Never attempt to operate
your grill on gases other than the type specified on the grill rating plates.
Your grill operates at 7-inch water column pressure. Verify supply pressure with your local gas
company. If supply pressure is different than 7 inch, contact a certified plumber for assistance.
Not for use with LP gas.
Purchase a 1/2-inch natural gas hose (12 inches long) which is CSA-certified under ANSI Z21.54
standards from a reputable dealer. The hose and its individual shut-off valve must be
disconnected from the gas supply piping system during any pressure testing on that system
at test pressures in excess of 1/2 psi (3.5 Kpa).
The hose must be isolated from the gas supply piping system by closing its individual manual
shut-off valve during any pressure testing of the gas supply piping system at test pressure equal
to or less than 1/2 psi (3.5 Kpa).
Do not use hard metal piping of any kind to connect this type of grill to natural gas source. Use
only hose specified by reputable dealer. Using hard metal piping or convoluted metal tubing is
an unsafe practice. Movement of the grill can cause breakage of metal pipe.
Connection should be made by a certified plumber. Supply the plumber with a copy of these
instructions. Incorrect connection can result in a gas leak with possibility of fire.
Follow the following steps to connect your grill to natural gas source.