59
2022
Innovative Vehicle Solutions
DIAG++
Operator‘s Guide
DIAG++
ILAS-E Auto front / rear Settings:
Auto raise / Auto lower.
Drop:
The load where the ILAS solenoid is de-energised
causing the axle to drop. (default - 90 %)
Raise:
The load where the ILAS solenoid is energised causing
the axle to raise. (default - 50 %)
Sensor configuration:
Disables the wheel speed signal when a sensed axle is
raised. (default - not sensed)
Raise with speed, drop with speed are further options
that can be selected when the drop and raise loads are
reached.
Notes: for all ILAS-E types:
1.
Raising happens fully automatically below the raise threshold.
2.
Dropping happens fully automatically above the drop threshold.
3.
If front and rear lift axles are configured the one with the higher raise threshold raises first!
4.
If front and rear lift axles are configured the one with the lower drop threshold drops first!
Raise speed
If the option ‘raise with speed’ is set for any lift axle,
then the axle will not lift before the set speed (the
default is 50 km/h).
Example is for manoeuvring before getting on to the
highway.
Drop speed
If the option ‘drop with speed’ is set for any lift axle,
then the axle will drop automatically the vehicle speed
falls below the set speed (the default is 1 km/h).
