4 Transport and storage
4.4 Permitted aids for transport
39
–
Ensure that no persons are standing in the path of transport or under suspended
loads.
–
Always lift the packing units or pallets of the Positioning clamping pin slowly and
carefully to ensure stability and safety.
–
Do not remove transport safeguards (if present) until the component has been finally
fixed in place at the location of use.
4.4
Permitted aids for transport
Shackles or hooks must be selected according to the transport weight of the packaging
units or pallets of the Positioning clamping pin and are only to be attached to the holding
points provided for this purpose.
Avoid contact of the carrying chains or ropes with the packing units or pallets of the
Positioning clamping pin. If this is not possible, take appropriate precautions to prevent
damage to the packing units or pallets of the Positioning clamping pin .
Adjust the length of the carrying means so that the packaging units or pallets of the
Positioning clamping pin can be transported horizontally.
4.5
Scope of delivery
The scope of delivery of the Positioning clamping pin consists of the following
components:
–
Positioning clamping pin
–
Original operating instructions
4.6
Interim storage
If the Positioning clamping pin are not used immediately after delivery, they must be
stored carefully in a protected place. The Positioning clamping pin must be stored
temporarily in such a way that they are protected from cold, moisture, dirt and mechanical
influences.
For the recommended storage conditions for the Positioning clamping pin, please refer to
chapter “3.3.2 Ambient conditions“.
In case of improper storage, no liability will be accepted for any damage caused!
