2 Safety
2.5 Special danger warnings / residual dangers
20
2.5.5
Crushing hazards
WARNING
Risk of injury due to crushing!
Serious injuries may occur during operation!
–
Never operate the Positioning clamping pin with defective components.
Never put built-in safety components out of operation.
–
Make sure that the Positioning clamping pin are properly fastened.
–
Make sure that no limbs of your own or other persons are under
suspended loads.
2.5.6
Dangers due to suspended loads
WARNING
The following special hazards must be expected when operating the
Positioning clamping pin:
Hanging loads can fall down, causing a danger to life!
There is a danger of tipping over!
–
During use or at work always wear the personal protective equipment
necessary for the work in question (protective clothing, protective gloves,
safety helmet and safety shoes).
–
Make sure that you and other persons are not under suspended loads.
–
Place or set down the load safely.
–
The maximum load must not be exceeded (see "3.3 Technical data").
–
Perform a daily function test before each start-up.
–
In the event of mechanical damage, take the Positioning clamping pin
out of operation immediately.
–
Position lifters above the centre of gravity.
2.5.7
Dangers due to improper storage
DANGER
Danger due to improper placement of objects!
Improper placement of objects inside or on the Positioning clamping pin
can lead to damage, malfunctions or total failure and impair safety!
–
Please note that it is forbidden to place objects on the Positioning
clamping pin . Remove all objects that are on the Positioning clamping
pin.
–
Make sure that workpieces are properly fastened.
