39 / 41
Hakki Pilke 35 Falcon
Translation
Version 10
thermal relay is easily tripped.
sufficient thickness of the supply
cable.
2.
The thermal relay is broken or
incorrectly adjusted.
The splitting action does not
start or stay on after the sawing
motion.
1.
The saw mechanism is worn and
does not activate the position
lock (Figure 18, item E)
2.
Fault in the splitting valve
1.
Adjust bolt E to extend the
length about 1 mm.
2.
Contact the retailer.
The splitting beam makes extra
splitting motions.
1.
Excessive speed at the tractor
power take-off.
2.
Other fault
1.
Adjust the speed to the cor-
rect level.
2.
Contact the retailer.
The splitting beam stops prema-
turely.
1.
The motion booster stops the
slide in the incorrect position.
1.
Grease the motion booster
sleeve and loosen the spring
as necessary.
5.2.
Jamming of the cutting blade
If the cutting blade gets jammed in the log, stop sawing and try again on another section of the log. If the cut is
misaligned because the bar drags to one side, the degree of sharpness of the saw chain must be checked. A chain
that is not evenly sharp will always drag towards the blunter side, which will make cutting a thick log impossible.
On the other hand, sawing with an evenly dull chain is inefficient, and the saw chain must be sharpened or re-
placed (see Section 4.7). A worn flange may also cause chain drag or jamming. In these cases, the flange must be
serviced and/or turned or replaced with a new one.
5.3.
Jamming of wood on the splitting blade
If a piece of wood gets jammed on the splitting blade in a situation where the splitting force is insufficient to push
the piece past the blade despite several attempts to do so, do the following:
1.
Restore the splitting cylinder to its initial position with reversing lever A (Figure 11).
2.
Ensure that the log to be split does not exceed the maximum allowable dimensions.
3.
Lift the splitting blade to the highest possible position with lever G (Figure 11) and activate the splitting.
4.
If necessary, cut a sufficiently thick piece of wood (approx. 10 cm), place it into the splitting groove be-
hind the jammed piece, and activate the splitting process. The new piece will then push the bottom
part of the jammed piece past the blade.
5.
Lower the blade by approx. 5 cm and repeat step 3. Repeat step 4 until the jammed log has passed the
blade, piece by piece.
