HYDROK – Trouble shooting
9 Trouble shooting
Possible fault causes and the tasks to correct these
faults are described in the following section.
If faults occur more frequently, the maintenance inter-
vals must be shortened to correspond to the actual
system load.
Contact the manufacturer if there are faults that can-
not be corrected by following the instructions below;
see the service address on the back of this operating
instruction.
9.1 Safety
Trouble shooting
The following always applies:
5.
xx
1. Determine the cause of the fault.
2. Depending on the type of fault, either have autho-
rized specialized personnel correct the fault, or
correct it yourself.
The trouble shooting table provided below lists
personnel who are authorized to correct the
fault.
3. If there is a fault that was not caused by the clamp-
ing device the cause of the fault may be in the ma-
chine area. See the operating manual for the ma-
chine in this regard.
88
Order h49 7144.907-333
