HYDROK – Assembly
4. Put the stationary chuck on the machine table.
5. Screw in the mounting screws through the station-
ary chuck into the machine table and tighten them
only finger tight.
Check the face run:
6. Adjust the dial indicator at the front side of the
clamping element reception and/or housing and
check the face run. Find the 0-position
7. Tighten the mounting screws according to the
manufacturers order.
6.3.2 Installation of the HYDROK 32 RD and the HYDROK 40 SE
8. x
Two people are required for this task.
Special tools required:
Allen wrench
Tool for expander
The hydraulic supply of the stationary chuck is carried
out via the base plate.
The stationary chuck can be centered either on an
outer diameter or on an inner diameter.
Fig. 27
Caution!
Property damage due to missing seal rings
By removing the seal rings the clamping device
may become leaky.
When remove the plug the seal ring must re-
main in the stationary chuck.
1. Remove the plug from the rear side of the clamp-
ing device.
Property danger due to not fitting hydraulic
connections!
With not fitting of the hydraulic connections of
base plate and stationary chuck the O-rings
can be destroyed!
When connecting the hydraulic by the base
plate, make sure that the connectors for the
hydraulic at clamping device and pipe fit.
Please use preferably the HAINBUCH base
plate [see optional accessories].
Order h49 7144.907-333
69
