HAI lumina, Advanced Application Manual

Page: 83 / 116

Page 75
Set Up Area
To configure different area options, from the Setup menu, press the 5 (AREA) key.
Mode Change Delay
The
Mode Change Delay is the time, in seconds, that you have before programs, associated with changing the Lumina mode, are
executed. For example, this delay is used when you are leaving your home and change the Lumina mode to Away, if you don’t
want all of your inside lights to turn off at that instance but would rather a delay between when you set the mode and when the
lights actually turn off. This delay is used in conjunction with the delay feature of a
Mode Event Program .
The default Mode Change Delay is 15 seconds. You may change it from 15 to 180 seconds.
MODE CHANGE DELAY: 15
15-180 SECONDS
Beep On Trouble
If the Lumina detects any troubles with itself or one of the zones connected to it, it will display a message on the screen and beep
the keypad twice per second, continuously (i.e. beep beep...beep beep...). You can silence this sound by pressing the ' * ' key.
However, if the trouble occurs again, the beeper will start beeping again.
If you do not wish to hear the beeping sound when a trouble occurs, set
Beep On Trouble to No.
The default setting for
Beep On Trouble is Yes.
Set up Miscellaneous
To configure Miscellaneous items in the system, from the Set Up menu, press the 6 (MISC) key.
High Security Mode
In
High Security Mode , the Master or Manager code is always required to do the following functions:
•
Any Control functions
•
Any Temperature Control
•
View the Event Log
•
Access the system from a local phone
With
High Security Mode Off, no code is required to access a local telephone.
If your system is set up with
High Security Mode On, the display will request the Master or Manager code whenever you select
one of these functions. Simply enter your Master or Manager code.
Your system was shipped from the factory with
High Security Mode Off, which allows you to view the event log and access the
local phones without having to enter a code.
Announce Alarms
If an HAI Two-Way Audio Module is being used in a system, this item enables the system to speak the type of alarm and zone
over a speaker on premises.
The default for
Announce Alarms is No.
Enable Freeze Alarm
If there are any Thermostats, Indoor Temperature Sensors, or PESM in a system, they can also be used to detect a freeze
condition -
See Freeze Alarm . The default for Enabled Freeze Alarm is No.