HAI lumina, Advanced Application Manual

Page: 19 / 116

Page 11
Telephone Connections
If the optional Telephone Access Kit (P/N: 44A01-1) has been purchased, connect as follows:
1.
Install the supplied RJ31X jack as shown in the following diagram.
2.
It is imperative that the phone line coming into the house be connected to a grounded surge arrestor outside the premises. It
is the responsibility of the telephone company to provide this surge arrestor.
3.
Inspect the incoming phone lines. The first thing that they should go to is a small box on the outside of the premises. There
should be a heavy ground wire coming from this box going to a cold water pipe or a separate grounding rod. If there is no
surge arrestor or if the ground wire is missing, have the customer insist that the telephone company install one for the safety
of the customer.
4.
When wiring an RJ31X jack, make sure that the incoming phone lines go to the telephone company surge arrestor before they
go to the RJ31X jack. When the RJ31X is installed as shown, locate the green, red, brown, and gray spaded wires from the 8
conductor phone cable and connect to the section on the Lumina controller marked 'PHONE'. Plug the modular end of the
cable into the RJ31X jack. If necessary, bend the tab up on the plug to ensure a tight fit that will not fall out.
5.
Verify the following if you have trouble during check out: With the system running, the RJ31X jack properly connected and
all phones on-hook (hung up), the PHONE LED, located in the upper left corner of the controller, should be OFF. If it is on,
reverse the RED and GREEN wires to both the house phones and the telephone company wires at the RJ31X jack. When the
receiver is picked up on any phone, the PHONE LED will come on. When the phone line rings, the PHONE LED will light.
6.
If the Lumina is accessed on an in house telephone, the Lumina will disconnect the phones from the phone company lines
and supply its own talk voltage to the phones. The PHONE LED will be on in this case.
COMPUTERS
PBX, AND
TELEPHONES,
TO ALL HOUSE
JACK(S)
PHONE
HOUSE
RJ11
GREEN(+)
GREEN(+)
ENSURE TIGHT FIT
NECESSARY TO
BEND TAB UP IF
SURGE ARRESTOR
INTERFACE AT
TO TELCO
RED(-)
SURGE ARRESTOR
ACCESS
CUSTOMER
RED(-)
INTERFACE
TELEPHONE
NETWORK
MUST BE GROUNDED!
SURGE ARRESTOR
GR
EE
N
RED BROWN GR
AY