53
96-5047 rev L June 2005
8.4 L
UBRICATION
To check the lube level of the Rotary Table, view the level of lube visible in the eye with the Table stopped. The
eye is located on the side panel of the Table. The lube level should reach the middle of the sight glass*.
*HRT210SHS - The lube level should not show more than 1/3 on the sight glass. The oil level must be to the
bottom of the sight glass at a minimum.
To add lube to the Rotary Indexer, locate and remove the pipe plug from the lube fill port. This is located on the
top plate above the eye (see Figure below). Add Mobil SHC-630 oil until the proper level is reached. Replace
the fill port bolt and tighten.
Replace the oil every 2 years.
Oil Fill Port
Eye
Fill Port location for Rotary Table
8.5 C
LEAN
U
P
At the end of the workday or shift, it is important to clean the rotary table. The table should be free of any chips
or grime. Clean with a chip brush and apply a coat of a rust preventative. Do not use air gun around front or
rear seals. Chips may damage seal if blown in with an airgun.
Front Platter Seal
Rear Brake Seal
Front and Rear Seals for HRT.
Summary of Contents for HRT 160
