Haas+Sohn HRT 160, Operator'S And Service Manual

Page: 39 / 65

38 96-5047 rev L June 2005
The following examples show the program as you would enter it into the control. We will assume each time
that you have cleared out the memory. The bold-face type surrounded by [ ] indicates data that you would enter
into the controller.
Example #3
We want to drill a four-hole pattern, and then a five-hole pattern on the same part.
STEP STEP SIZE FEED RATE LOOP COUNT G CODE
01 [90.000] 080.000 [4] [91]
02 [72.000] 080.000 [5] [91]
03 0 080.000 1 [99]
Example #3 could have also been done using Circle Division.
STEP FEED RATE LOOP COUNT G CODE
01 080.000 [4] [98]
02 080.000 [5] [98]
03 080.000 1 [99]
Example #4
We want to index 90.12 degrees (90.12 o ), start a seven-hole bolt pattern, and then return to the zero position.
STEP STEP SIZE FEED RATE LOOP COUNT G CODE
01 [90.120] 080.000 1 [91]
02 0 080.000 [7] [98]
03 0 080.000 1 [88]
04 0 080.000 1 [99]
Example #5
We want to index 90 degrees (90
o
), then slow feed for 15 degrees (15
o
), repeat this pattern three times, and
return home.
STEP STEP SIZE FEED RATE LOOP COUNT G CODE
01 [90.00] 080.000 1 [91]
02 [15.00] [25.000] 1 [91]
03 [90.00] 080.000 1 [91]
04 [15.00] [25.000] 1 [91]
05 [90.00] 080.000 1 [91]
06 [15.00] [25.000] 1 [91]
07 0 080.000 1 [88]
08 0 080.000 1 [99]