34
Guidelines
If the blade server is successfully powered off, the system power LED turns steady amber. For more
information about the position of the system power LED, see "
."
Powering off the server from its operating system
Use the SUV cables to connect a monitor, mouse, and keyboard to the blade server, and then shut
down the operating system to power off the server.
Powering off the server from the OM Web interface
Access the server management page from the OM Web interface and power off the server. For more
information, see OM online help.
Powering off the server by using an OM command
Execute the
psu-blade
command to power off the server. For more information, see the OM online
help.
Powering off the server from the HDM Web interface
The blade server can be powered off through the power management function of the blade server
HDM Web UI. For the specific operations, see the
H3C Servers HDM Online Help
.
Powering off the server forcedly by pressing the power on/standby button
NOTE:
This method forces the server to enter standby mode without properly exiting applications and the
operating system. Use this method only when the server system crashes. For example, a process
gets stuck.
Press and hold the power on/standby button for more than five seconds to power off the server.
Configuring the blade server
The following information describes the procedures to configure the server after the server
installation is complete.