TLC2100SHD Operating Instructions
Document 900.0060 Rev 1.01
13
Flashes when Timer mode is entered and one or more of the following conditions exists:
•
A cassette is not loaded.
•
A cassette without a safety tab is loaded.
•
The Timer has not been programmed.
Y/C
Indicates that the Y/C input is selected in the System Options submenu.
Lock Indicator
Lights when the recorder is in the Security Lock mode. All front panel controls (except
the Record Check function) are disabled when lock indicator is lit.
B, R
B or R will light when the Brown (+azimuth) head or Red (-azimuth) head mode is
selected in the System Options submenu.
Digital Counter (0000)
Shows the tape time counter. Each digit incremented represents one second of time in
2-hour or 6-hour speed. If the counter is reset to
0000
at beginning of tape, a T-120
cassette increments the counter to approximately
7200
at end of tape. In the 6-hour
speed, a T-120 cassette increments to approximately
21600
at end of tape. In modes
other than Record, the counter increments or decrements only where a recording was
made; that is, when going over a section of blank tape, the counter will not change.
Tape Speed Indicator (000), Speed Annunciator
Displays the selected tape speed. The Speed Annunciator lights in conjunction with the
Tape Speed Indicator.
HD
Lights when the unit is in the High Density (HD) mode. Note that if HD is selected in
the menus, recording can be made in HD speeds. For a listing of HD speeds, see
Record
on page
8
for more information.
