25
TLC 2100
271-0498-4852503#
When you first turn on the unit, the message "Set Clock" will be displayed flashing on
the monitor screen. The clock is set in the Time/Date submenu:
Time/Date
Exit
Time:
12:00:00A
Date:
1/01/96
Day:
Sun
To set the clock in the Time: Date submenu:
In this example, the time & date will be set for 2:56 PM, March 6, 1997. It will be assumed
that the date format is mm/dd/yy (month/day/year). The date format will be covered
in the "Display Options: Date Format" section of this manual.
• If necessary, press PROG. to display the Main Menu
• The cursor will be next to the Time/Date submenu line.
• Press PROG. to display the Time Date submenu.
• The cursor arrow will be next to the Time parameter line.
• Press PROG. to begin editing. "12", the hour position, will begin to flash.
• Press UP 14 times until "2" is displayed. "A" (AM) will change to "P" (PM).
• Press NEXT. "00" will begin to flash in the minutes position.
• Press UP or DOWN until "56" is displayed.
• Press NEXT to move to the next parameter to be edited, that is, "1" in the Date
parameter line. Note that the Seconds need not be programmed; as soon as NEXT
is pushed, the seconds will begin to count off automatically.
Note
:It is not necessary to exit the Time Parameter and then enter the Date
parameter. NEXT and PREV. will move to the next or previous parameter, even if
they're in another menu line.
• The "1" in the month position will begin to flash.
• Press UP twice. 3 (March) will be displayed.
• Press NEXT. "01", the day position, will begin to flash.
• Press UP until "06" is displayed.
• Press NEXT. "96" will flash.
• Press UP once. "97" will be displayed.
• Press PROG. to end editing for this line. The cursor arrow will be displayed again
next to the Time line.
• Note that the Day line will now display "Thu". The Day parameter is automatically
entered after the Date parameter is entered.
• Press UP to move the cursor to the Exit line.
• Press PROG. to exit the submenu. The Main Menu will now be displayed.
• The cursor will be next to the Exit line of the Main Menu. Press PROG. to exit the
Main Menu.
• Your monitor will now display the Time and Date, often known as a Time/Date
stamp. See "Display Options" for more information about the formats of the Time/
Date stamp. If you have not yet programmed any of the Display Options submenu
parameters, the Time/Date stamp should appear as follows:
3-06-97 THU A00
02:56:17P 02
Note:
The letters "PL" may appear before "THU". "PL" stands for power loss - it is
displayed when the power is interrupted. It often appears when the unit is first switched
on. "PL" may be turned off by pressing the Alarm Reset Button (Button #26).
Time/Date
Submenu
Example of
Setting the Clock
& Navigating a
Menu
