Gyrus Acmi PlasmaKinetic SuperPulse, User Manual

Page: 15 / 52

SECTION 4 GENERAL INFORMATION
Gyrus ACMI PlasmaKinetic SuperPulse Generator USER MANUAL
Part Number: 144012-MB
4A. Gyrus ACMI SuperPulse Generator Indicators and Displays
Fig 4.1
Keypad
:
Standby/On, Up, Down Arrows and Mode / Menu Button
Standby / On
The Standby/On button switches the Generator back and forth between the Standby and
Idle / Ready states. The green indicator will change from flashing to continuous when the
equipment state changes from Standby to Idle / Ready by pressing the button. To place
the generator into Standby press the standby button. When prompted press again to
confirm entry to Standby is required.
Following an error condition the generator may be reset by pressing the Standby/On
button twice.
Up/Down Arrows
Depressing the up or down arrow when parameter change is permitted increases or
decreases the parameter step-wise. Holding the button down will increase or decrease
the value in preset steps
Mode / Menu
This button provides access into the waveform selection and setup menus.
Repeated short presses will give access to the frequently used functions, listed below: -

Cut waveform selection (PK)

Coagulation waveform selection (VP/DES)

Volume
Page 4-1
Standby
/ On
Button
Red warning
lamp
Connector Cable
sockets
PlasmaKinetic and
ThermoKinetic Up/Down
Mode /
Menu
Button
Vapor Pulse and Des
Up/Down
Standby / On
indicator
Active instrument
indicator
Gyrus Medical Ltd
Superpulse System
(c) 2003
Version V2.22
SECTION 4
GENE
R
AL INFORMATION