Gyrus Acmi PlasmaKinetic SuperPulse, User Manual

Page: 22 / 52

SECTION 4 GENERAL INFORMATION
Gyrus ACMI PlasmaKinetic SuperPulse Generator USER MANUAL
Part Number: 144012-MB
Page 4-8
Non-critical (Recoverable) Faults
Fault
- If a fault is detected during set-up or during use a fault code message is displayed
as indicated by the “Fault Code XXX REF XX” symbol on the front panel display (Fig 4.10
Screen for recoverable fault display ). Refer to Section 9, Operating Room Troubleshooting.
Fig 4.10 Screen for recoverable fault display
Critical (Non-recoverable) Errors
Red Warning Symbol
- Except during the self-test routine and a non-critical failure,
illumination of the red warning symbol on the front panel when accompanied by the “Error
Code XXX REF XX” symbol (Fig 4.11 Screen for critical error display) on the front panel
display indicates a critical failure. In the case of a critical failure,
DO NOT ATTEMPT TO
USE THE UNIT
. Please refer to Section 11 for information.
Fig 4.11 Screen for critical error display
SuperPulse Generator Connectors and Sockets
The PK Single Function connector cable is connected to the generator through either of the
two PK connector cable sockets on the front panel of the generator (Fig 4.1).
The electrical power cord; footswitch cable and protective earth cable are connected to the
generator through fittings on the rear panel (Fig 4.17).
A five-way cable may be available to enable use of tri-polar instruments.
BUTTON STUCK
Fault code
400 Ref 15
INTERNAL FAILURE
Error code
200 Ref 25
SECTION 4
GENERAL INFORMATION