Günter & Hauer
6
CONNECTION
IMPORTANT WARNING:
The operations described below must be performed by
qualified personnel in accordance with applicable regulations.
THE MANUFACTURER IS NOT RESPONSIBLE FOR DAMAGES WHICH
RESULT FROM INAPPROPRIATE INSTALLATION OF THE DEVICE AND
VIOLATION OF THE ABOVE RULES.
Appliance must be disconnected from the mains before carrying out any work on it. If
a power supply is required to perform an operation, make sure that all necessary
precautions are taken in this case.
Do not install the appliance near flammable materials (eg curtains, towels, etc.)
CONNECTION TO THE GAS NETWORK
In accordance with current regulations, it is possible to make a fixed connection or use
a flexible stainless steel hose. When using flexible metal hoses, be careful that they do
not touch moving parts or they do not get crushed. Take the same precautions if the hob
is installed in combination with an oven.
IMPORTANT
: To ensure proper operation, energy saving and long lasting service, the
supply voltage and gas pressure must meet the recommended values. The adjustable
connecting piece is attached to the gas main pipe with a G1 / 2 nut. Insert between the
seal parts as shown in the scheme below. Screw in the parts without tightening, adjust
the fitting in the required direction and tighten all connections.
1 – Pipe with a nut at the end
2 – Sealant
3 – Adjustable connecting piece
After installation, check that the pipe
connections are completely sealed, use
a soap solution and never use a flame.
