Hélicoptères Guimbal
SECTION 4
CABRI G2
NORMAL PROCEDURES
4-9
Before starting engine
Harnesses .............................................................................. Both fastened
Cockpit ............................................................. All objects correctly secured
Pedals .................................................................................... Full travel free
Collective ............... Friction released, full travel free, then move back down
Cyclic ..................................................................................... Full travel free
Breakers .................................................................................................... In
Hourmeter ...................................................................................... Checked
Fuel shut-off valve ................................................................... Checked ON
Altimeter .................................................................................................. Set
All switches ........................................................................................... OFF
Carburetor heating switch ..................................................................... Auto
MASTER switch ...................................................................................... ON
NR switch ......................................................................................... Backup
NR green light .......................................................................... Checked ON
Lights and NR horn automatic check .........................Monitored, all working
except STARTER
EPM starts
Watch flight log
Push #2 key to enter configuration page.
Set configuration as desired ................................. refer to page 7-13
Push #1 key to freeze flight log page, push again to carry on.
Watch self-test
If a parameter is failed, the page stays until acknowledged.
Refer to page 2-12 for no-go parameters.
Watch flight screen
No alarm except :
OIL P
-
FUEL P
-
OIL T
-
CARB T
(if OAT
corresponds)
If engine is cold .............. Cross-check OAT - CHT - OIL T - CARB T
Fuel quantity ........................................................................... Check
Governor ..................................................... OFF, check GOV OFF light ON
Mixture ............................................................................... Forward, full rich
Note 1 :
Before starting, NR green light, GOV OFF, OIL P, ALT. lights are
on. CLUTCH light may also be ON.
Note 2 :
The EPM has preflight functions described page 7-11 and
following pages.
Note 3 :
When the helicopter is soaked at very low temperature, (less than
-17°C / 0°F) the EPM display may not start at once. Switch
MASTER OFF and wait a few minutes in the cabin before
switching it back ON.