Guardall Windsor 500, Programming Manual

Page: 70 / 108

Windsor 500 Programming Manual - Issue C
- 70 -
Micromimic Interface
The serial port may be optioned to send alarm data to a Micromimic (see Hardware/Serial
Port). The format is 1200 baud, no parity, 8 data bits and 1 stop bit. The protocol for a
message is;
Event Code + Event CR + LF ;where CR = Carriage return (ASCII code 8D)
LF = Line Feed (ASCII code 8A)
All messages are 4 bytes long including the termination characters (CR + LF). The event
codes and numbers are shown in the table.
Event Type Event Code Event Number
Cct Bypass on 31 1-128 circuits
Cct Bypass off 32 1-128 circuits
Duress 37 1-50 users
Log On 39 1-50 users
Set 43 1-7 Area
Unset 45 1-7 Area
Key Set 52 1-7 Area
Key Unset 53 1-7 Area
AC Loss 55 NONE
AC Restore 56 NONE
Power Fail 57 NONE
Reset 64 1-7 Area
Cct Off Line 68 1-128 circuits
Auto Set Fail 71 1-7 Area
Keypad Lockout 78 0-9 keypads
Auto Set/Fault 79 1-7 Area
Auto Set 81 1-7 Area
Auto Unset 82 1-7 Area
Line fault 83 NONE
Isolate Cct on 101 1-128 circuits
Isolate Cct off 102 1-128 circuits
Isolate Conc on 109 1-16 concentrators
Isolate Conc off 110 1-16 concentrators
Line Blocked 117 NONE
Test call 118 1-50 users
First PIN 120 1-50 users
Verified Alarm 122 1-128 circuits
Circuit Restore 123 1-128 circuits
GSR Access 126 NONE
Keypad Tamper 200 0-9 keypads
Cct Alarm 201 1-128 circuits
PA 202 1-128 circuits
Fire 203 1-128 circuits
Cct Tamper 204 1-128 circuits
Conc Tamper 205 1-16 concentrators
Control Tamper 206 NONE
Bell Tamper 208 NONE
Low Battery 210 NONE
Entry Alarm 211 1-128 circuits
UI Fire 213 0-9 keypads
UI Medical 214 0-9 keypads
UI Panic 215 0-9 keypads
Bat. Test Fail 216 NONE
Auth. Fail 217 NONE
The event number is not required by some event codes. In such cases the second byte is
always 0.