GST100 Intelligent Fire Alarm Control Panel
Installation and Operation Manual
Page 25
(3) FAULT OUTPUT: There is a FAULT OUTPUT circuit and an LED for the FAULT
OUTPUT.
Selecting
“3. Outputs” in the screen of Fig. 6-8 will enter the screen for setting the output status,
as in Fig. 6-13.
The first screen
Fire Out [*]
Abnormal Out [ ]
The second screen
Sounder Out [*]
Fault Out [*]
Fig. 6-13
[*]
represents the output is currently enabled, and [ ] represents the output is disabled.
Pressing
Enter
in disabled screen, it displays
“[ ]” showing the output is disabled. If an output is
already disabled (displaying
“[ ]”, it remains unchanged when
Enter
is pressed. Pressing
Enter
in enabled screen, it displays
“
[*]
”. If an output is already enabled (displaying “
[*]
”, it
remains unchanged when
Enter
is pressed.
6.5.4 Disabling / Enabling Pre-alarm
As described in Section 5.6, an alarm from a detector will be considered as a pre-alarm signal
if the FACP works in delay mode while pre-alarm is enabled.
Selecting
“4. Pre-Alarm” in the screen of Fig. 6-8, will enter the screen for enabling pre-alarm
as shown in Fig. 6-14.
Pre-Alarm [*]
Fig. 6-14
[*]
represents the pre-alarm is currently enabled, and [ ] represents it is disabled.
Pressing
Enter
in disabled screen, it displays
“[ ]” showing the output is disabled. If the
pre-alarm is already disabled (displaying
“[ ]”, it remains unchanged when
Enter
is pressed.
Pressing
Enter
in enabled screen, it displays
“
[*]
”. If the pre-alarm is already enabled
(displaying
“
[*]
”, it remains unchanged when
Enter
is pressed.
Summary of Contents for GST100
Page 1: ......