GSK928TE
Ⅱ
Turning CNC System User Manual
39
Note 1:
The spindle speed is controlled by P12 Bit0. When Bit0=0: it is the multi-gear control; when
Bit0=1: it is 0-10V analog voltage control.
Note 2:
When P12 Bit0=1, P11 Bit4 is invalid, i.e. the spindle is always controlled by the converter. At
the moment, the output point S1, S2, S3, S4 is controlled by M41, M42, M43, and the
corresponding output point cannot be controlled by the spindle gear shifting key.
4.4.13 Manual Cooling Control
In “
Manual
“ mode, press the key to control the cooling ON/OFF.
Cooling ON/OFF
Press
to switch the cooling ON/OFF. Start the cooling, and the system displays the
cooling is
ON
and LED is
ON
; stop the cooling, and the system displays the cooling
OFF
and
LED
OFF
.
4.4.14 Manual Tool Change Control
This system can control the tool post with 4 tool selections. It also can be extended to 8 tool
selections when T5
～
T8 tool selection signals are input in code mode. Three kinds of tool
change methods are as follows:
●
Set P12 Bit1 to 0 and press
once, and the tool post rotates to the next controllable tool
number and the system displays the corresponding one.
●
Set P12 Bit1 to 1, press
once and
, and the tool post rotates to the next
controllable tool number and the system displays the corresponding controllable tool number. If
is pressed, the tool post cannot execute the tool change when other keys are pressed.
●
Input
T * O
directly by keyboard (* standing for rotating to the required controllable tool number)
and then press
, and the tool post rotates to * which is pointing to the controllable tool,
and 0 stands for canceling the tool offset.
Note 1:
For the first two methods, do not execute the tool compensation but the tool change, but
for the third, execute the corresponding tool compensation after inputting the tool
compensation number behind * .
