GSi Protek 1000 Series, User Manual

Page: 68 / 73

Then, the screen will look like the following figure 3-13.
Figure 3-13: Automatic/Manual Range Adjustment
Attention
: capacitance measurement without manual range mode.
CHAPTER 4: Troubleshooting
1. The scope meter cannot be turned on.
1) Check the power cable connection.
2) Ensure the power switch is turned on.
3) After the above inspection, restart the scope meter.
4) If the problem still remains, please contact us for help.
2. The measurement result is 10 times higher or lower than
the value expected.
Check if the probe attenuation is the same as the channel attenuation.
3. The waveform is displayed on the screen but is not stable
under the oscilloscope mode.
1) Check the Trigger Source and notice if it is set to the channel in use.
2) Check the Trigger Type.
4. When select the average sampling in the sampling mode
or select a longer display time in the display mode under
the scope meter, the display speed is slow.
It is normal in the above case.
5. After the Acquisition is set to “Averages” or Display
1000MENUAL.indd 65 2009-04-06 �� 9:07:25