5. Set Band-Width Limit
With CH1 taken for example, input a signal containing high frequency component.
Press
CH1→F5→F3→OFF
, to set up bandwidth limit to “OFF” status. The
oscilloscope is set to full bandwidth and passing the high frequency component in the
signal.
The waveform is displayed as Figure 2-9:
Figure 2-9
BW limit Off
Press
CH1→F5→F3→ON
, to set up bandwidth limit to “ON” status. It will reject the
frequency component higher than 20MHz.
The waveform is displayed as Figure 2-10:
1000MENUAL.indd 24
2009-04-06 �� 9:07:05
Summary of Contents for Protek 1000 Series
