Grundig GU-CI Series, User Manual

Page: 47 / 82

English
47
enabled, the only detect the alarms triggered by human or vehicles, but need to consume
more CPU of IPC. If it is not turned on, all objects passing through the line will be detected.

Rule Number
：
Max set 4 rule number. Draw a rule area on the area map, and click to the next
few rules, then you can draw rules on the area map. The rule switch and rule type of each rule
are independent, and they need to be opened, closed or set separately.

Rule Switch
：
The switch of each rule

Rule Type
：
Setup to each rule, A->B means can detect A to B direction moving, B->A means
can detect B to A direction moving, A ←→ B means can detect two directions moving.

LCD (Line Crossing Detection) : click on the area, draw a square area of four points, and then
set it as a perimeter intrusion detection rule. You can draw four rule areas, each rule has a
corresponding digital ID. Click the red small box next to the digital ID of the rule, and you can
drag or stretch the perimeter intrusion detection rule area.
（
Note: when LCD (Line Crossing Detection
）
is triggered, "S" will appear on the channel, and a
pop-up window will appear in the lower left corner of the page, as shown in picture 4-10. In
addition, PID / LCD and PD & VD / FD are mutually exclusive and cannot be enable at the same
time).
8.7.1.5 SOD - Goods lost & Legacy
By this function, alarms are triggered when legacy or lost items is found in monitoring area.
Figure 8.21

Enable
：
Enable or disable SOD