E32.0.02.6C-04
Manual for connection and operation of the
GIA 2000 / AAG and GIR 2002 / AAG
page 22 of 30
7. Switching points and alarm-boundaries
(only for GIR 2002)
Remark: The difference between this menu and the output configuration menu is that only in the output
configuration menu it is possible to select the output function and to adjust the delay and the
preferred state of switching functions.
A change of the input configuration can possibly influence the switching points and alarm boundaries. (e.g.
changing of scaling for standard signals or changing of resolution or unit for temperature
)
Therefore you may check your output settings after the input configuration has been changed.
General description and notes to the operating of the menu
By means of
button 1
you can go to the next parameter.
Additionally a given changing in the parameter setting can be con-
firmed by this button and the new value will be saved. Afterwards it
will be changed to the parameter view again.
By means of
button 2
and
3
you can go from the parameter view to
the parameter setting and adjust its value there.
Hint:
The buttons 2 and 3 are featured with a ‘roll-function‘. When pressing the button once the value will be raised
(button 2) by one or lowered (button 3) by one. When holding the button pressed for longer than 1 sec. the
value starts counting up or down, the counting speed will be raised after a short period of time.
The device also features a ‘overflow-function‘, when reaching the upper limit of the range, the device switches
to the lower limit, vice versa.
By means of
button 4
a
given changing will be cancelled in the parameter setting. The changing will be dis-
carded and the former parameter value will be preserved.
In the parameter view button 4 closes the menu.
Please note:
If you don’t press any button for more than 10 sec. in the parameter setting, the adjustment will be
cancelled, the changing discarded and it will be changed to the parameter view. If you don’t press
any button for more than 60 sec. in the menu, the menu will be automatically closed.
7.1. Menu calling
-
When pressing button 1 for >2 seconds the menu to select the switching points and alarm-boundaries
will be called.
-
Depending on the configuration you have made in the output configuration menu you will get different
Display values. Please follow the specific chapter for further information.
Description
Selected
as output
Go on in
chapter
Note
No output, device is used as displaying
device
no
--
Calling of the menu not possi-
ble
2-point-controller
2P
7.2
min-/max-alarm
AL.F1
7.3
ON/SP
SET
min.
OFF/Hy.
1
2
max.
ALARM
Scale
Analog
CAL
Scale
Analog
CAL
ON/SP
SET
min.
OFF/Hy.
1
2
max.
GIR/GIA
ALARM
SET
1
2
3
4
