Installation
Page
27
of 82
5.2 Electrical
WARNING
Risk of electrocution
Before starting the fully installed WMS for the first time, check and ensure
that all electrical connections have been correctly wired in accordance with
the electrical documentation.
5.2.1 Electrical documentation
The electrical documentation is delivered separately and covers all versions
and options. Carefully read the electrical documentation and determine
which options are relevant for the system(s) delivered.
If the electrical documentation is lost, new documentation can be obtained
on request. Please state the system serial number to ensure that you
receive the relevant version of the electronic documentation from Green
Instruments. The power supply for the WMS must be in accordance with the
power supply specified in the electrical documentation.
5.2.2 Power
The characteristics of the WMS power supply must be as specified in the
electrical documentation.
ATTENTION
Failure to use the specified power supply can result in system failure.
5.2.3 Communication
The system uses Modbus TCP/IP communication or an optional Modbus
RTU line. The Modbus mapping is specified in section 5.3.2 and the correct
ethernet port is identified in the electrical documentation. The Modbus
communication must be tested to ensure correct use before bringing the
system into operation.
To set the System Modbus IP address - see section 5.3.1 & 5.3.2.
The WMS also supports Web Viewer (VNC) - see section 5.3.3.
The WMS also supports optional remote connectivity for servicing and
troubleshooting purposes - see section 5.3.4.
