SWPR
Parameter
Options
Description
LED Color
Latch LED
Backlight
Alarm
Fav
EXPERT BELOW
Atten
Delay
Delay Time
Zeromatic
Special
Search Dir
Hit Count
0-7
Sets LED color to 0-7 as defined in the GLOB
menu. By default, 0=LED Off, 1=Red, 2=Yellow,
3=Green, 4=Cyan, 5=Blue, 6=Magenta, 7=White.
On or Off
Normally the ALERT LED is active only while the
object is receiving a transmission. When Latch is
on, the ALERT LED will remain lit after the
transmission is complete, unless overridden by a
subsequent object that is also using the ALERT
LED.
On, Off or Flash
Controls whether the backlight should be on, off or
flashing while the object is active.
None, Chirp, Hi-Lo, Alert,
Ring, 2-Chirp, Fast Hi-Lo,
DTMF#
Sets the Audible Alarm for the SWPR object. When
an Audible Alarm is selected, the selected alarm will
play anytime the scanner stops for activity on the
SWPR object while scanning.
On or Off
When On, the SWPR object is a member of the
Favorites Scan List.
On or Off
When on, applies 20 dB of attenuation to all hits
received on the SWPR search. Useful in areas
where interference from nearby strong signals is
present.
On or Off
Controls whether a Delay is used to wait for reply
traffic after a transmission on the SWPR search.
1-200
Sets the amount of time (in 100 millisecond
intervals) for the wait for reply delay if Delay is On,
e.g., 20=2 seconds.
On or Off
When on, enhances the scanners ability to lock on
to the actual center frequency of a search hit
instead of an adjacent frequency.
On or Off
SWPR works by quickly sweeping the RF spectrum
in 1 MHz increments to find nearby strong signals.
If the 1 MHz sweep indicates that activity is present
in the 1 MHz range, SWPR sweeps that range to
find the source.
Up or Down
Sets search direction used when SWPR object is
active.
Numeric value
Increments each time a transmission is received on
the SWPR object. Global “Hit Counts” must be set
to ON. Press the
Dflt
softkey to reset to 0.
0716
User Manual
Page 112
