![background image](http://html1.mh-extra.com/html/gravograph/m10-jewel/m10-jewel_user-manual_2258802053.webp)
Gravograph Machines - Soft setup
Setting softlink between PC and engraving machine
USB
connection
1. Plug a single machine onto an USB port of your PC. Power up it.
> Plug machine onto port, power up it
2. The setup wizard checks the compatibility between GT Smartstream 3.xx and
machine firmware (embedded program that carries out engraving instructions).
• When compatibility is ok, the wizard jumps to step 4.
• Otherwise the last firmware version will be set up. Machine beeps when operation
is over.
> Updating firmware
3. Power off your engraving machine, then power up again.
> Power off machine
> Power up machine
4. The machine is automatically detected as new device on an USB port of your
PC.
Click "Software correctly installed" in Software compatibility wizard of
Windows Vista.
In Windows XP Add new detected device wizard asks if devices plugged
onto your PC should be checked.
a.
Click "Not this time."
Next>
Click.
b. The wizard asks if you expect Windows to set up machine driver.
Click "Install software automatically (recommended)".
Next>
Click.
c.
A message notifies that driver is not Windows certified.
Continue
Click.
d.
Finish
Click when setup is over.
5. In Start menu or in Control panel double-click Printers: check that your
machine is displayed as new GT Smartstream printer
6. Give this printer the name of your engraving machine.
COM
connection
1.
Next>
Click. Configure your machine as Windows printer in Properties dialog box.
> Click Next to select the type of port to communicate with machine
2.
Ports
Click tab.
3. Click COM followed by the number of the port where you plugged the cable
that links the PC and the engraving machine.
4.
General
Click tab.
5. Give this printer the name of your engraving machine followed by the selected
port (for example COM1: or COM2:).
6.
OK
Click.
7. In Printers check that your machine is displayed as new printer
3