M10 JEWEL Machine - Electronic Engraving Machine
. 26
First Contact
6. Loosen the 2 screws (V1) (in the center of the chuck) slightly. Turn the tool
at 90° in the clockwise direction (1) and remove the tool (2).
2/3
8. Turn the diamond tip (D2) (for bracelets) at 90° (the tip on the left) (1). Insert it (2) and turn
it at 90° (3) in the anti-clockwise direction (the tip is directed downwards) . Tighten the 2
screws (V1) to immobilize it.
The diamond tip is the material to be engraved exactly where the engraving should start.
9. Lower the diamond tip using the screw (V2) until it touches slightly the bracelet. Tighten the
screw (V2).
7. Touch (START) to continue
