First Contact
M10 JEWEL Machine - Electronic Engraving Machine
. 37
9. Tilt slightly (1) and insert the diamond holder for outside engraving equipped
with the diamond tip (D7) for bracelets in the location.Then turn it at 90°
(2) (the tip on the left). Insert it and turn it at 90° (3) in the anti-clockwise
direction (the tip is directed downwards). Tighten the 2 screws (V3) to
immobilize it.
The diamond tip is the material to be engraved exactly where the engraving should start.
3/3
10. Lower the diamond tip using the screw (V4) until it touches
slightly the bracelet. Tighten the screw (V4).
11. Touch
(START) on the control panel of the machine, to start the engraving.
For your own personal safety and to avoid any risks of being crushed by the machine
during engraving, do not stand near the tools.
In the event of a problem, touch
(PAUSE) to stop the engraving process
The machine will momentarily pause.
To continue with the rest of the engraving, touch
(START)
To stop engraving completely, touch one of the arrows of the joystick.
Engraving is finished, when the machine is ready to
receive a new file:
You can remove the bracelet, or launch again the engraving process for
a better result.
