M10 JEWEL Machine - Electronic Engraving Machine
. 36
First Contact
6. Remove any tool which can be present in the center of the chuck : Loosen
the 2 screws (V1) (in the center of the chuck) slightly. Turn the tool at 90°
in the clockwise direction (1) and remove the tool (2).
2/3
7. Touch (START) to continue.
8. Open the trapdoor of the location (E) above the chuck and Loosen the 2 screws (V3) slightly.
If necessary, replace the diamond tip (D8) by the diamond tip (D7) on the diamond tip holder
for outside engraving and tighten (V4).
