First Contact
M10 JEWEL Machine - Electronic Engraving Machine
. 17
Switching the machine on
Switch on the machine main stop button (L) to position I.
After few seconds, the machine will emit a short "beep". The LED (L2) is lit.
Leave the machine plugged in even if it is not in constant use.
Problems
If one of the operational signs is absent (for example : the LED (L2) is not lit)., check the following points :
• Are the two ends of the mains cable correctly connected ?
• Is the mains plug connected ? Is it live ?
If the machine does not come on, before calling a technician, please check power connections
to the mains socket.
Switching the machine off
Switch the main stop button (L) to position O.
Switch off the machine for the following reasons :
- if you are leaving the workstation (end of the day, for example),
- physical damage (fall, fire, liquids coming into machine…),
- mechanical/electrical/electronic faults, leading to a possible breakdown,
- in case of major problem or mechanical block of the machine,
- to reboot,
- for external cleaning.
Switching on again
If the machine or the programme which runs it crashes you may have to reboot the machine.
If this happens, switch the machine off. Wait 30 seconds and switch it on again.
Respect this rule. This time allows any electric shock to the machine, possibly damaging
the power supply, to be avoided.
