![background image](http://html1.mh-extra.com/html/gravograph/l-solution-100-ex-fibre/l-solution-100-ex-fibre_user-manual_2258787056.webp)
L-SOLUTION 100 Ex Fibre machine
. 56
First contact
The indicator light
GREEN INDICATOR LIGHT
CONDITION
REASON
ON
The LASER machine is initializing.
OFF
The LASER machine has finished processing a file
and has returned to the home position.
The LASER machine is ready to receive a file.
The LASER machine has been paused while running a
file.
During a Pause.
RED INDICATOR LIGHT
CONDITION
REASON
ON
The LASER machine is initializing.
OFF
The LASER machine has finished initializing
and is ready to receive a file.
During a Pause
FLASHING
The file is engraving.
System operation
The indicator light will act differently depending on the current
state of the LASER system.
Charts 2 and 3
describes the conditions of the indicator
light during different modes of operation.
The Process Controls
These control the actual running of the LASER system
The "
START
" button runs the current file displayed in the
«File» menu.
If a file is running, the «
PAUSE
» button halts the engraving
or cutting process. When paused, the motion system arm
stays above the current engraving. When ready to continue
operation, press the «START» button and the system will
begin cutting or engraving again exactly where it left off. If
you wish to run the file from the beginning after pressing
the «PAUSE» button, press on one of the arrows of joystick
or «CANCEL» the motion system arm will move to its home
position in the upper right corner of the engraving area, and
then press the «START» button («ENGRAVING START»).
We advise you to use the «PAUSE» button instead of the
front door in order to pause the machine. Opening the door
to turn off the LASER and to pause the motion system should
only be used for safety or emergency reasons.
The
"NEXT FILE SELECTION"
button displays the next file
in the systems memory and makes it the current file. This
button is inoperative if a file is currently running.
The
"PREVIOUS FILE SELECTION"
button displays the
previous file in the systems memory and makes it the current
file. This button is inoperative if a file is currently running.