L-SOLUTION 100 Ex Fibre machine
. 10
First contact
Sécurité LASER
This LASER machine contains hermetically sealed a pulsed Fiber LASER that produces
intense and invisible LASER radiation at a wavelength of 1.064 microns (μm)
(0.419 10
-6
inch) in the infrared spectrum.
This LASER system contains a Fiber LASER in a Class I enclosure. However, due to the
presence of a visible red LASER diode (power < 1mW), the entire LASER system is classified
as Class 2.
- The entire system is completely enclosed with a protective housing. This will completely contain the invisible C02 LASER
beam under normal use. However, the red diode LASER is a visible LASER beam.
DO NOT STARE INTO THE BEAM
OR VIEW DIRECTLY WITH OPTICAL INSTRUMENTS.
- The user door consists of two protective windows in compliance with the standard
DIR 1064L6 (CE)
and is safety
interlocked and will disable the LASER beam from firing when the user door(s) are opened. The red diode LASER beam
is
NOT
safety interlocked and can be activated with the door either open or closed.
Do not modify or disable any safety feature of this system. Do not operate any
system that has had its safety features modified, disabled, or removed.
Improprer use of controls and adjustments, or performance of procedures other than
those specified in this manual, may invalidate the safety of this system.
CDRH and EC regulations require all LASER manufacturers to affix warning labels in specific locations throughout the
equipment.
The following warning labels are placed on the LASER system for your safety. DO NOT
remove them for any reason. If the labels become damaged or have been removed for
any reason, DO NOT OPERATE the LASER system and immediately contact Gravograph for
a free replacement.
1 label
:
On the back of the system next to the serial number tag. Visible when viewing the LASER system from the backside.
This machine is in compliance with American 21 CFR standards,
subchapter J except for deviations pursuant to LASER notice N° 50,
dated July 26, 2001.
2 labels
:
One is next to the beam window where the LASER beam enters the engraving area inside the LASER system and
is visible when the door is opened.
The second one is located on the LASER source where the LASER beam comes out. It is not visible under normal
operating conditions.
AVOID EXPOSURE - Visible and invisible LASER radiation is emitted
from this aperture.
Labels
:
On the LASER source. Not visible under normal operating conditions.
DANGER - Invisible and/or visible LASER radiation is present at
that place or when open. Avoid eye or skin exposure to direct
or scattered radiation. 21 CFR part 1040.10 - IEC 60825.1
LASER Class 4/IV - Wavelength: 1064nm (0.419 10
-6
inch) - 1,1mJ -
30-200ns - 20-500KHz - 22W Max.
LASER class 2/II - Laser Diode : 620-660nm - 1mW Max.
4 labels
:
One is next to the beam window where the LASER beam enters the engraving area inside the LASER system and
is visible when the door is opened.
The second one is on the right, on the #1 mirror cover.
The third one is located on the LASER head next to the access hole of the #2 mirror.
The fourth one is located on the nozzle of the head.
DANGER - Invisible and visible LASER radiation is present at that place.
Avoid eye or skin exposure to direct or scattered radiation.
LASER Safety
