May 16, 2016
T2 Elite 2/Pro 2/Express 2/Elite/Pro/Express Service Manual
77
Motherboard/BIOS startup
When the names of HDD or SSD (for data) are displayed in POST screen after restart,
check the RAID status. Refer to
"Verifying, building, and rebuilding a RAID volume"
. Replace a HDD/SSD, or build/rebuild a RAID volume, if necessary.
When the names of HDD or SSD (for data) are not displayed in POST screen, check
a status. Refer to
"Media disk problems" on page 86
5. Select "Hard Drive BBS Priorities" using the
[
↑
] or [
↓
] key on the keyboard, and then press
the [Enter] key.
6. Select "Boot Option #1" using the [
↑
] or [
↓
]
key on the keyboard, and then press the [Enter]
key.
7. Select the SSD (for the system) using the [
↑
] or
[
↓
] key on the keyboard, and then press the
[Enter] key.
8. Select "Boot Option #2" using the [
↑
] or [
↓
]
key on the keyboard, and then press the [Enter]
key.
9. Select the recovery UFD using the [
↑
] or [
↓
]
key on the keyboard, and then press the [Enter]
key.
10.Make sure that "Boot Option #3" is set to
"Disabled". If "Disabled" is not set, set it to
"Disabled".
11.Press the [F10] key on the keyboard.
The "Save & reset" screen appears.
12.Select [Yes] using the [
←
] or [
→
] key on the
keyboard, and then press [Enter] key.
The T2 restarts.
Problem
Possible Causes
Corrective Actions