Graco Therm-O-Flow Plus, Instructions Manual

Page: 49 / 82

49 309085
Dual Ram Cross-Over Control Function
Starting/Stopping X-Over Operations
(continued)
For changing DRUM B, the same sequence of screens
is displayed as shown.
C H A N G E
X – O V E R D R U M
– > O N < – > B <
E X I T O F F F 5
F1 F2 F3 F4 F5
C H A N G I N G
X – O V E R D R U M
– > O N < – > B <
E X I T O F F D O N E
F1 F2 F3 F4 F5
X – O V E R
– > O N
< –
E X I T O F F
F1 F2 F3 F4 F5
NOTE: For systems that do not contain cross-over
modules, the X-OVER screen will show the following.
X – O V E R
N O T E N A B L E D
E X I T
F1 F2 F3 F4 F5
If starting the X-OVER when no cross-over modules
exist on the system, there will be communication errors
and the X-OVER will be disabled. (Starting the X-
OVER automatically ENABLES it, expecting to com-
municate with cross-over modules mounted to each
unloader assembly.)
Another way to enable the X-OVER modules when
available, is to proceed through the SETUP screens to
the CROSS-OVER CONFIG (option 5) selection. The
last row of the screen will show F1 (ON) which when
pressed will ENABLE the X-OVER. To disable the
crossover module, press the F1 (OFF) key. The OFF
will change to ON, but the cross-over is disabled until
F1 (ON) is pressed again.
A = D E D I C A T E Z O N E S
B = F A C T O R Y S E T U P
( G r a c o u s e o n l y ! )
o n E X I T
F1 F2 F3 F4 F5